HP ProLiant DL170e G6 Server - Manual (Page 79)

CLI commands 79
— Numerical values between 0–9
o SL-APM differentiates a password from an account_name (you have a choice between the two
parameters, but not both) by the fact that the “password” parameter is in quotes while the
account_name parameter is not in quotes. If the account_name parameter is used, then you are
prompted for the new password.
Set power
• Command:
SET POWER {ON|OFF|ENABLE|DISABLE} {ALL | {|ALL}}
where:
ALL is used when the command applies to all nodes. You can also use it when the command applies to
all the server nodes in a particular SL server enclosure.
refers to the SL-APM, PDM1, or PDM2 port numbers.
refers to the SL-APM Distribution Module port number or HP Intelligent Modular PDU
Extension Bar outlet number.
refers to the SL server node.
• Description:
o Turns power on and off to SL enclosures.
o SET POWER ALL shows the HP Power Management Controller Utility hardware and firmware
versions as well as the license status of all servers in the enclosures.
Set serial
• Command:
SET SERIAL
• Description:
o Configure the serial console baud rate.
o Serial access to the CLI will be by default 115200 bits/s, no parity, 8 data bits, and one stop bit
(“115200 N 8 1”). You can configure these parameters through the CLI.
o Valid baud rates are 300, 1200, 2400, 4800, 9600, 14400, 19200, and 115200.
Set syslog
• Command:
SET SYSLOG {|NONE}
• Description:
Sets or clears the sending of SL-APM log messages to a remote syslog server. Local logging is
unaffected.