HP Matrix Operating Environment Software - Manual (Page 86)

IMPORTANT: For SAN Catalog Storage Entries and SAN Pre-populated Catalog Storage Entries,
the Remove Volume action returns the storage volume to the storage catalog as an available
resource. Unmask catalog-based storage volumes before removing the storage volumes. For non-boot
volumes, uncheck the Masked check box. For boot volumes, use HP Storage Provisioning Manager
to change the presentation state of the storage volume.
Figure 30 Add storage pool entry volume and path definition
Validation status
After you have specified your storage pool entry, you can optionally confirm that the server WWN
has been associated with the storage port WWN and LUN by pressing the Validate button.
Validation on this screen is not available for SAN Catalog Storage Entries and SAN Pre-populated
Catalog Storage Entries. Catalog-based storage is validated when presentation is complete.
See “Validating storage” (page 89) for more information.
Manage server WWNs
The Manage Server WWNs table allows you to manage the server WWNs for the storage pool
entry.
The Status column displays the presentation status of the storage pool entry.
Press Get/Refresh Pool Entries to see updated status. The values that can be displayed in the Status
column are:
•
Presentation Initiated
•
Presentation Pending
•
Presentation Completed
•
Presentation Completed with Errors
•
Inoperable (can be displayed with any other status)
86 Defining storage for logical servers