HP Matrix Operating Environment Software - Manual (Page 52)

To allow all incoming traffic, specify 0.0.0.0/0.
To allow SSH connections to a server, select the TCP protocol, specify a Start Port of 22
and an End Port of 22 and IP Sources of 0.0.0.0/0.
d. Click Add.
3. (Optional) To remove the firewall rule, click the Trash icon.
Viewing the details of a firewall
Details of a firewall associated with a template and service are shown on the Firewall Details pane
at the bottom of the infrastructure orchestration console Templates and Services tabs. Select a
service or template and click Details, then select the Firewall Details tab.
In the following template, the firewall configured for the template allows inbound traffic over the
TCP protocol on ports 2 through 4 from locations defined by CIDR IP notation 10.0.0.0/24.
Inbound traffic is also allowed over the UDP, ICMP, and TCP protocols, with the details shown
below.
52 Installation and configuration