HP Matrix Operating Environment Software - Manual (Page 205)

Add Disk request for an ESX virtual server does not complete successfully after CMS crash recovery
Add Disk request for an ESX virtual server does not complete successfully when resumed after CMS
is recovered from a crash. Issue
A CMS crash occurred while vCenter was creating a virtual disk, causing an incomplete disk
creation. Possible cause
Action •
Remove the partially created virtual disk file from vCenter.
•
Refresh server resources from logical server management.
• Re-issue the Add Disk request.
Log files
How can I find out more details about an error?
How can I find out more details about an error? Issue
— Possible cause
See the hpio-controller.log file located at ..\Program Files\HP\Matrix
infrastructure orchestration\logs
on the CMS.
Action
vCenter server is not configured in Systems Insight Manager or becomes unavailable
vCenter server is not configured in Systems Insight Manager or becomes
unavailable. Matrix infrastructure orchestration may generate a large number of these messages
causing the infrastructure orchestration log file to grow very rapidly.
Issue
If there are ESX hosts registered with Insight Control virtual machine management, but vCenter
credentials are not configured in virtual machine management, infrastructure orchestration keeps
logging an error that virtual machine management is not configured to communicate with vCenter. Possible cause
Action •
Register the system credentials of the discovered vCenter node in Systems Insight Manager and
add the VME credentials using the Systems Insight Manager Options
→VME Options→Add or
Edit VME Credentials menu selection.
• Verify that the “VMware vCenter Management Webservices” service is started.
•
As a workaround (if you are not performing VM provisioning on ESX) and this message is causing
the infrastructure orchestration log file to grow rapidly, configure infrastructure orchestration to
Hyper-V only mode. Change the following property in the ..\Program Files\HP\Matrix
infrastructure orchestration\conf\hpio.properties
file:
##### HYPERVISORS ####
# Set this value to true if the only hypervisors in the
# managed environment is MS Hyper-V
only.hyperv.hypervisors = true
After updating the hpio.properties file, restart the HP Matrix infrastructure orchestration.
Miscellaneous issues 205