HP Matrix Operating Environment Software - Manual (Page 37)

c. In the Job Properties window, make sure that the modified Erase ProLiant Hardware job
displays, then click OK to close the window.
Configuring Ignite-UX
Matrix infrastructure orchestration supports Ignite-UX version C.7.11.439 (HP-UX 11.31 1009) or
later for HP-UX 11iv3 deployment. (HP-UX 11iv3 0709 or later is required for Integrity VM.)
The Ignite server must have NFS configured and the tftp and bootps services enabled in /etc/
inetd.conf
.
a. To set up NFS and export the directories Ignite needs, run:
/opt/ignite/lbin/setup_server –n
b. To enable tftp and bootps services, edit /etc/inetd/conf, and uncomment the "tftp" and
"bootps" lines and then run:
inetd –c
Depending on the client being installed (for example, if the client has a graphics card or keyboard
attached), the system may prompt to identify the keyboard language. To avoid this, edit /var/
opt/ignite/config.local
by adding the following line:
_hp_keyboard="USB_PS2_DIN_US_English"
NOTE: Only HP-UX release 11.31 1003 or later can be installed on the following Integrity
blades:
•
BL860c i2
•
BL870c i2
•
BL890
•
BL890c i2
The complete list of documentation for Ignite-UX is available at http://hp.com/go/ignite-ux .
Discovering the Ignite-UX deployment server
Matrix infrastructure orchestration provisioning requires that the Ignite-UX deployment server is
discovered or rediscovered.
To discover a Ignite-UX deployment server in Systems Insight Manager:
1.
Select Options
→Discovery.
Configuring deployment servers 37