Brother NC-2010p - Manual (Page 35)

CHAPTER 2 UNIX NETWORK CONFIGURATION (TCP/IP)
2-8
d) The UNIX arp command.
e) DEC NCP, NCL, or ccr utilities
f) Brother BRCONFIG NetWare utility (A Novell Network is necessary)
g) BRAdmin (Novell Network necessary)
h) Serial port (If your print server has a serial interface)
The following step (i,j,k) is effective way, when you change IP address.
i) TELNET (A valid IP address must already be programmed into the
print server).
j) HTTP (A valid IP address must already be programmed into the card
print server).
k) Other SNMP based management utility
These configuration methods are described in the following paragraphs.
✒ Note
The IP address you assign to the print server must be on the same logical
network as your host computers, if it is not, you must properly configure
the subnet mask and the router (gateway).
Using the printer front panel to allocate an IP address (printers
with LCD panels only)
Refer to the Quick setup guide for details on how to configure IP address
information using the printer control panel.
Changing the IP Address using the BRAdmin32 application
Start the BRAdmin32 utility (from Windows 95/98 or NT4.0).