Brother NC-2010p - Manual (Page 107)

USER’S GUIDE
11-8
1. When you get the “ Local> “ prompt after connecting to the
console, enter the command:
SET POP3 ADDRESS ipaddress
where ipaddress is the IP address of your POP3 server
(consult with your network administrator if you do not
know this address).
2. Enter the command:
SET POP3 NAME mailboxname
SET POP3 PASSWORD emailpassword
where mailboxname is the name of the remote print server
mailbox and emailpassword is the password associated with
this mailbox. Usually the mailbox name is the same as the
first part of the E-mail address that you defined previously
(for example, if the E-mail address is
[email protected], then the mailbox name is
emailprinter).
3. The print server is set by default to poll the POP3 server
every 30 seconds. If you wish to change this value, enter the
command:
SET POP3 POLLING rate
where rate is the polling rate in seconds.
4. Type EXIT to exit the console and save the changes. You
have now completed configuring the remote print server.