Brother NC-2010p - Manual (Page 140)

USER’S GUIDE
A-20
If the red LED does not go out after about two minutes, check to make sure
that you correctly entered all parameters and that your network connections
are good. Then power the print server off and then on again, enter the
SET
LOAD ENABLE command, and exit the remote console to retry the
download.
Downloading from a VINES Server
To download from a Banyan VINES file server, first copy the load file into
any directory on your file server (for example, E:). Then use the BRAdmin
utility (see Chapter 9 Section C) to download the new firmware. Go to the
main screen, select the File menu, and choose Reload. Then select the
drive and directory in which the load file is located, click on the file name,
and click on OK to get the Firmware Reload menu. Select the desired
print server(s) and click on Reload. Click on OK when the reload is
complete.
Obtaining Firmware Updates
To get latest firmware updates, "access" the Brother WWW server on
www.brother.com.