Brother NC-2010p - Manual (Page 33)

CHAPTER 2 UNIX NETWORK CONFIGURATION (TCP/IP)
2-6
- Press the F3 key to get a list of available interface, and select the
desired one as the Name of interface using the cursor keys (“Dumb” is
a good choice).
- Select “Direct” as the Connection.
- Enter the desired Device name (
/dev/lp generally works).
- Select "Hardwired" as the Device.
- Select "No" for the Require banner field.
Other Non-Standard Configurations
DEC TCP/IP Servers for VMS(UCX)
You need to run the sys$system:ucx:$lprsetup command, specify
a printer name, and then enter the print server IP address as the remote
system name. Specify one of the print server services (see beginning of this
section for options) as the remote system printer name (accept the defaults
for other questions).
TGV’s Multinet
TGV's Multinet requires you to run the MULTINET CONFIGURE
/PRINTERS command, then use the ADD command to add a printer,
specifying the print server IP address, a protocol type of LPD, and one of
the service options described at the beginning of this section as the remote
print queue.
Wollongong’s PATHWAY
First make sure that you have the Access option with lpd enabled. Then
enter the print server name and IP address in the
TWG$TCP:[NETDIST.ETC]HOSTS file, run the LPGEN program, and
execute the command: add
queue/rmachine=prnservername/rprinter=prnserverser
vice , where queue is the name of the queue, prnservername is the
print server name from the hosts file, and prnserverservice is the
print server service name.