Brother NC-2010p - Manual (Page 14)

CHAPTER 1 NOVELL NETWARE CONFIGURATION
1-3
Configuring the Brother Print Server (Queue Server Mode in
Bindery emulation mode)
1. Start the appropriate BRAdmin program.
2. One or more print server will appear in the list (the default node names
are BRO_xxxxxx_P1 or BRO_xxxxxx, where "xxxxxx" is the last six digits
of the Ethernet address).
3. Select the print server that you wish to configure and double click it.
You will be asked for a password. The default password is "access".
4. Select the Netware tab.
✒ Note
If necessary change the “Print Server Name”, the default Netware print
server name will be BRO_xxxxxx_P1 where xxxxxx is the Ethernet
address of the print server. Be careful! Changing the name may impact the
configuration of other protocols because the print server service names
will be altered.
a. If it is not already selected, select Queue Server mode.
b. Click on the Add Queue button. (BRAdmin32 users click the
Change Bindery Queues button.
<BRAdmin users>
Click on Create to create a new queue and type in the desired queue
name on the desired file server (or you may select an existing
queue). BRAdmin should automatically find all Netware file servers
in your network and display their names in the “File Server” box.
You must have supervisory access rights to create a queue on the
Netware server you wish to configure. Click OK, Yes, and then OK
again to add this queue. Click on Close, OK, and then select Yes to
save the changes, then click OK.
>
Select the Netware server which you wish to configure. Then select
the New Queue button. Type in the queue name that you wish to
create. Once you have done that highlight the queue name you
created an then click on the Add button. The queue name you create
will then move to the Service Print Queues box. Click on Close and
then OK
Now exit the BRAdmin application.