Brother NC-2010p - Manual (Page 20)

USER’S GUIDE
1-9
3. If you did not specify the print server name in the BRCONFIG
command, select the corresponding server name from the list of print
servers.
4. When you get the message that the print server is connected, type the
default password “access” in response to the "#" prompt (the
password will not echo), and then press the ENTER key in response
to the Enter Username> prompt.
5. When you get the Local> prompt, type:
SET NETWARE SERVER servername ENABLED
Where servername is the name of the file server on which the print
queue will reside. If there is more than one file server that you wish to
print from, repeat this command as many times as necessary.
6. Type EXIT to exit the BRCONFIG remote console program and save
the changes and start the Novell PCONSOLE utility.
7. Select Print Server Information (NetWare 3.xx) or Print Servers
(NetWare 4.1x; ignore the warning message) from the Available
Options menu.
8. You will be shown a list of current print servers. Press the INSERT
key to create a new entry, type in the Netware print server name
(BRO_xxxxxx_P1 by default, where "xxxxxx" is the last six digits of
the Ethernet address) and press ENTER. Return to the main
Available Options menu by pressing ESCAPE.
9. Select the Print Queue Information (NetWare 3.xx) or Print
Queues (NetWare 4.1x) menu option to see list of configured print
queues.
10. Press INSERT to create a new queue on the file server, type the new
queue name and press ENTER. The name does not have to be related
to the name of the print server resources, but should be short and
convenient for users to remember.
11. Make sure that the new queue name is highlighted, and then press
ENTER to configure the queue.
12. Select Queue Servers (in NetWare 4.1x, this item is called Print
Servers) and press ENTER to specify which network print servers
can print jobs from this print queue. The list will be empty, since none
have been selected yet if this is a new queue.
13. Press INSERT to get a list of the queue server candidates and select
the print server service name from step 8, Press ENTER.