Brother NC-2010p - Manual (Page 123)

APPENDIX
A-3
GENERAL SERVER COMMANDS
CLear FATal
Deletes fatal error log
CLear POrt portname JOB
Clears current entry in the print server's internal queue for the specified
portname (P1 for the printer.)
EXIT/^D
Exits print server console
HElP
Provides information on available commands
INitialize
Resets print server
SET DEFAULT
Sets print server parameters to factory defaults
SET LOAD DIsable
Disables firmware reload after exit
SET LOAD ENable
Enables firmware reload after exit
SET LOAD HOst
Sets node name of boot host for (NetWare firmware load)
SET LOAD IP aa.bb.cc.dd
Sets IP address of load host (TCP/IP firmware load)
SET LOAD SOftware
Sets host filename of firmware to load
SET PAssword
Sets console password (default password is access)
SET PROtect
Set console protection password to prevent access to SET commands (use
UNPROTECT command to access SET commands)
SET SERVEr DEScription
Sets node description string displayed with SHOW SERVER command
CLear SERVEr STRing stringnumber
Removes a string number (refer to Appendix B)
SET SERVEr STRing n "..."
Defines server BOT/EOT string (see Appendix B)
SET SERVIce [EN|DIS]
Enable or disables specified protocol on the specified service.
SET SERVIce BOT nn
Set service BOT string to nn (see Appendix B)
SET SERVIce EOT nn
Set service EOT string to nn (see Appendix B)
SET SERVIce FILter nn
Set service filter to nn (see Appendix B)