beautypg.com

Downloading from a netware server, A-18 – Brother NC-2010p User Manual

Page 138

background image

USER’S GUIDE

A-18

Downloading from a NetWare Server

To download from a NetWare server, first copy the load file e.g.

Firmname.bin

into the \

login

directory on your

SYS

partition

(

SYS:\LOGIN

). Using the \

login

directory will eliminate any potential

file protection problems.

Connect to the print server remote console using BRCONFIG and enter the
following commands in response to

Local>

prompt.

SET LOAD HOST

fileservername

SET LOAD SOFTWARE SYS:\LOGIN\Firmname.bin
SET LOAD ENABLE

where fileservername is the name of the file server. When you type a
CTRL-D to exit the remote console, the file

Firmname.bin

will then be

loaded into the print server. The red diagnostic LED will blink during the
load process and will go out when the process is complete.

If the red LED does not go out after about two minutes, check to make sure
that you correctly entered all parameters and that your network connections
are good. Then power the print server off and then on again, enter the

SET

LOAD ENABLE

command, and exit the remote console to retry the

download.