Brother NC-2010p - Manual (Page 129)

APPENDIX
A-9
NetBIOS/NetBEUI Commands
SET NETBeui Enable/Disable
Set NetBEUI Transport protocol enable/disable
SET NETBeui Domain
Sets the NetBEUI Domain/Workgroup name
SHow NETBeui
Show NetBEUI configuration
The following three commands are only available on Brother print servers
which have version 3.59 or later software. For latest software releases go to
the Brother web site at www.brother.com
SET NETBios IP Enable Enable/Disable
Set NETBIOS over TCP/IP Enable/Disable
SET NETBios Domain
Set NETBIOS Domain/Workgroup name
SHow NETBios
Show NETBIOS configuration
Internet Print Commands
SET POP3 Address aa.bb.cc.dd
Purpose: Sets POP3 Server IP address
SET POP3 Enable/Disable
Enables or disables POP3 protocol
SET POP3 Polling nn
Sets POP3 server polling frequency in seconds
SET POP3 Name
Sets POP3 mailbox name for print server
SET POP3 Password
Sets the POP3 Mailbox password
SET SMTP Address aa.bb.cc.dd
Sets the SMTP server IP address
SET SMTP ENable / DISable
Enable or disables SMTP capabilities
SHOW POP3
Shows POP3 parameter settings
SHOW SMTP
Shows SMTP parameter settings
DLC commands
The following DLC/LLC configuration commands are available
from the NC-series print server console:
SET DLC [EN|DIS]
Enables or Disables the DLC protocol