Milestone XProtect Advanced VMS 2014 - Manual (Page 236)

Milestone XProtect ® Advanced
VMS 2014
Administrator's Manual
www.milestonesys.com 236 Feature configuration
Color Description
Red Initial state. Registered, but not connected to the ST server.
Yellow
Registered. Connected to the ST server, but not added as
hardware.
Green Added as hardware. May or may not be connected to the ST server.
When you add a new camera, its status is always green. The connection status is reflected by
Devices on Recording Servers in the Overview pane. In the Overview pane, you may group your
cameras for an easier overview. If you choose not to register your camera at the Axis dispatch service
at this point, you can do so later from the right-click menu (select Edit Axis One-click Camera).
Axis One-Click Camera connection properties
Name Description
Camera password
Enter/edit. Provided with your camera at purchase. For further
details, see your camera's manual or
www.axis.com .
Camera user See details for Camera password.
Description Enter/edit a description for the camera.
External address
Enter/edit the http address of the ST server to which the camera(s)
connect.
Internal address
Enter/edit the http address of the ST server to which the recording
server connects.
Name If needed, edit the name of the item.
Owner authentication key See Camera password.
Passwords (for Dispatch
Server) Enter password. Must be identical to the one received from your
system provider.
Passwords (for ST server)
Enter password. Must be identical to the one entered when the
Axis One-Click Connection Component was installed.
Register/Unregister at the
Axis Dispatch Service Indicate whether you wish to register your Axis camera with the
Axis dispatch service. Can be done at time of setup or later.
Serial number
Hardware serial number as specified by the manufacturer. The
serial number is often, but not always, identical to the MAC
address.
Use credentials
Select the check box if you decided to use credentials during the
installation of the ST server.
User name (for Dispatch
Server) Enter a user name. The user name must be identical to the one
received from your system provider.
User name (for ST server)
Enter user name. Must be identical to the one entered when the
Axis One-Click Connection Component was installe