Thermo Fisher Scientific CyberScan pH 10/pH 100 - Manual (Page 32)

28
9 ADVANCED SETUP FUNCTIONS (FOR pH 100 ONLY)
The advanced setup mode lets you customized your meter’s preferences and defaults. The
Eutech Instruments’ standard CyberScan meter features four different programs that organize
all setup parameters. Each has been divided into several options. The programs and options
are elaborated under the following sections:
Program Description Sub-Group Functions Section
P 1.0 Software Initialization Memory Clear and Reset Options 9.1
P 2.0 View Electrode Data pH slope & offset, calibration data, & relative
mV offset 9.2
P 3.0 Meter Configuration Set pH resolution, READY setting, & auto-off
function 9.3
P 4.0 Communication Data
Setting Set baud rate, parity & stop bit. 9.4
To enter the SETUP mode, press the SET key from either the pH, Relative mV or mV
measurement [MEAS] mode. The meter automatically enters Program 1, Option 0 (P1.0).
NOTE: Entry to SETUP is only accessible from the [MEAS] mode.
Selection of the CON key confirms selection of the options chosen. The instrument then
automatically scrolls to the next program. Within each program, the user can use MI/ ! or
MR/ " keys to make appropriate selections. There are some options that only permit the
viewing of data and are useful for diagnostic purposes.
Ensure that the CON key is pressed to confirm your option in each program. Should you
desire to exit from the program after the confirmation of your choice or abort the [SETUP]
mode, press the CAL/MEAS key to return to the [MEAS] mode.
Addendum 1 shows the overall program setup and the factory default settings.