SHIMPO DT-601CG - Manual (Page 36)

Mode# Setting of the "Reset","Movement of Reset key","Selecting Reset Display", in Power ON
0 9 A B C D E F
0 9. 0 1 4
Selecting of Reset Display
0 : Display1, Display2 (Key input, movement Terminal Board Input)
1 : Current Display (Key input, movement Terminal Board Input)
2 : Display1 (Key input, movement Terminal Board Input)
3 : Display2 (Key input, movement Terminal Board Input)
4 : Key Input: Current Display,
Terminal Board Input: Display1, Display2
Action Mode of Reset key
0 : Not Reset
1 : Reset in a bit
2 : Need pushing key for 1 seconds
3 : Need pushing key for 2 seconds
Reset Node in Power ON
0 : Not Reset
1 : Reset
Reset Node in Power ON
Select record measured value at last time or delete measured value at last time in Power ON
0 : You begin measuring from last measured value.
1 : The last measured value is deleted and You begin measuring from display offset value.
Action Mode of Reset Key
0 : Not Reset
1 : Reset in a bit
2 : Need pushing key for 1 seconds
Count
Reset
Right Off
Input Signal
ON
OFF
Count
Reset
1 Seconds
Input Signal
ON
OFF
P34