SHIMPO DT-601CG - Manual (Page 33)

Mode# Setting of blank display, external input function, and overscale display
0 8 A B C D E F
0 8. 0 0 0
Overscale display
0 : 3rounds stop
1 : Endless
2 : Up key to show numbers of time go over (upper 2digits)
External input function
0 : Banned input
1 : Hold input
2 : Lap count input
3 : Display switch input
Blank display
0 : No Blank display (Display measured value)
1 : Blank display (No Display measured value)
[Blank display]
Set whether to display measured value or not. Only the measured value will blink when
"blank display" is set.
Alarm output LED and hold LED will functuon normally.
[External input function]
Setting the function of terminal block 2 to 3. When it is ON, hold LED will blink.
0 : Banned input - Bann the sensor input while ON
1 : Hold input - Keep displaying the current value while ON (blink when it functions)
measurement is proceeding internally
(overscale LED will be kept as well)
2 : Lap count input - Once it is ON, current value will be kept and blinking.
Measurement is reset and start measureing again.
Another ON will display the value calculated internally.
3 : Switch display input - Display 1 and Display 2 are switched at every ON.
P31