SHIMPO DT-601CG - Manual (Page 7)

[Option specification]
Weight, dimensions
Operating humidity
Option : DC type
Power source
Accessory
Protection grade
Body color
Case material
Others
Maximum output resolution
Output terminal
Electric voltage output
Electric current output
Output accuracy
Temperature
Output respond
Data backup
Mode Protect function
Reverse output
Analog
output
BCD
Output
BCD
Input
Output terminal
Output style
Output timing
Output action
TI (Ban-loading) signal
Output logic
Rating
Accessory
Input terminal
Input style
Input timing
Input action
Latch signal
Input logic
Rating
Accessory
Activate by Key operation (mode setting cannot be changed)
Write the each mode's set value and calculation value on to FRAM.
(over writing should be less than 10million times,about 10years conservation)
AC85 - 264V ( 50 / 60Hz )
DC12 - 24V ( ±10% )
0 - 50°C, 30 - 80%RH (non condensing)
400g W96xH48xD130mm ( W3.78"xH1.89"xD5.12" )
Chassis: mixed with ABS resin glass Terminal block
Black
IP66 equivalent
Terminal block cover 2pcs : main body attachment (material: acrylic,
transparent), Rubber packing (material: NBR, black), Unit rebel
From terminal block 19-20
Load resistance more than xxx
Load resistance les than xxx
Within ±0.3%(23°C) against displayed value (absolut e value)
+100ppm/°C
about 50ms ( as a duration to reach 90% output change)
12bit, D/A conversion system 4000 resolution
*maximum output range: up to 102.4% of each output's maximum value.
*with analog output, calculation is done against the displayed value with
7-segments LED. This might lower the revolution below 4000 depending
on the mode setting.
Reverse the electric voltage output(AV3-5) and electric current output (AI).
*With reverse output, maximum resolution is 4000 for each output style.
From BCD option collector (37pin)
Whole digit parallel, NPN open collector pulse output
Synchronized with the display refresh
With the output level "H", shunt with GND
Output with about 25ms width when data is refreshed
Data value and TI signal, positive/negative selectable
DC30V, 10mA Max.
D-sub37 pin male (soldered type) and connector hood
From BCD option connector (37pin)
Whole digit parallel, NPN open collector pulse input
With calculation cycle
D-sub37 pin male (soldered type) and connector hood
S
hunt the necessary digit's terminals with GND.
while inputting latch signal, data loading is prohibited
Data value, latch signal, positive/negative selectable
outflow electricity is about 3mA when shunting each input terminals
P5