SHIMPO SG-300 - Manual

1
SG-300 shown with DT-311A
Congratulations on your purchase of the Shimpo SG-300
Strobe Guard. We trust you will enjoy many years of
professional results from your Shimpo product.
Please read the entire instruction manual thoroughly
before initial set-up and operation; the information
contained herein will aid you in operating your Shimpo
Strobe Guard correctly and with excellent results.
If you have any questions regarding our product(s), call
your local Shimpo representative or contact Shimpo
Instruments directly for assistance.
Inspection
If upon delivery shipping damage is detected, do not
install the unit. Notify shipping carrier immediately for
damage claim instructions.
Features and Benefits
The SG-300 Stoboscope guard offers many features and
benefits including:
• Reduces costly repairs from dropping and
mishandling of stroboscopes
• Heavy-duty construction provides impact protection
for strobe’s controls, flash tubes and lens covers
• Easy to install
• Zero maintenance
Safety Precautions
Note: The stroboscope guard, model SG-300, is designed for
Shimpo Instruments’ stroboscope models DT-311, DT-311A,
DT-314, DT-315, DT-315A, DT-315EB or DT-315AEB. Please
check your stroboscope instruction manual to ensure that
you have the correct model for use with the Strobe Guard.
Exercise care when installing and uninstalling
the SG-300 strobe guard.
Do not disassemble or repair unit while in
operation.
Do not operate or store instrument in the
following places: explosive areas; near water,
oil, dust, or chemicals; areas where temperature
is above 104°F (40°C).
Ensure that the DT-311, DT-311A, DT-314,
DT-315, DT-315A or DT-315AEB stroboscope is
removed from any mounting devices before
installation or removal of SG-300.
The stroboscope is not designed for use in
hazardous environments where danger of
flame or explosion is present.
Model SG-300 Strobe Guard
INSTRUCTION MANUAL
SG-300 shown with DT-315A