SHIMPO DT-601CG - Manual (Page 12)

Caution!
(1) Check power supply
1. Be careful not to get a shock while wiring.
2. Pay attention if the unit is for AC power supply type or DC power supply type
3. In case of DC power supply, carefully check +,-. Do not connect other way round
(2) Check the names of terminals and wire them correctly
(3) Wiring differs depending on the sensors. Refer to the wiring diagram on P11.
Maximum power supply to sensor is DC12V 100mA (optionally: DC24V 60mA), never over load.
Wrong wiring might cause damages to sensor or circuit.
(4) Make sure to tighten the screws on the terminal block
(5) About BCD output, please refer to " BCD output" on P48
About BCD input, please refer to "BCD input" on P49
(6) With line receiver input(L1,L2) type, terminal block #9 and #10 will be input terminal.
So alarm output OUT1 and OUT2 cannot be used.
(7) Sensor's power source should not be used for other usage.
Reset
Sinusoidal input
(Option)
Sine curve input
(Option) Extra power supply
Line driver
(Option)
When line receiver input
BCD output/input(option)
NPN Open collector pulse output
Relay output
Power supply
Analog output (option)
( PhotoMOS relay )
P10