SHIMPO DT-725 User Manual

Instruction manual

Instruction Manual

Digital

Stroboscope/T

Stroboscope/Tachometer

achometer

Model DT

Model DT-725

-725

Features

Operational Precautions

Do not operate or store instrument in the following
places:

Explosive areas
Near water, oil, dust or chemicals
Areas where temperature is above 104°F (40°C).

Do not look at the emitted light for long periods of
time; it can be harmful to the eyes.

Do not disassemble or repair unit while in operation.

To mount the strobe on a tripod (or any other
mounting surface), use screw 1/4 - 20unc, length
8mm or shorter, for the tripod screw hole on the bottom.

Setter

The setter changes the flashing rate. Turn CW to
increase the rate, turn CCW to decrease rate.

x2 Switch

Pressing "x2" will double and display the flashing rate.

1/2 Switch

Pressing the "1/2" will divide flashing rate by two and
display it.

Plus (+) Switch

When object appears to be standing still, pressing "+"
will give the illusion that the object is moving towards
the opposite direction of rotation. This action increases
the rate slightly (phase shift) and is used to place the
object in desired position.

Minus (–) Switch

When object appears to be standing still, pressing "–"
will give the illusion that the object is moving towards
the rotating direction. This action decreases the rate
slightly (phase shif) and is used for the same reason as
above.

Input and Output Connectors

Phonejack (3.5 mm)
Tip: Signal
Sleeve: GND

Power switch with lock option