SHIMPO DT-601CG User Manual

Page 5

(3) Batch count operation

Setting condition

Automatic reset selection and re-output selection will be invalid
OFFSET = 0, OFFSET < PRESET A,

PRESET A = 0, PRESET A < OFFSET,

PRESET B > 0

(4) +1stage plus secondary output operation

Setting condition

Re-output selection will be invalid.
OFFSET = 0, OFFSET < PRESET A,

PRESET A = 0, OFFSET > PRESET A ,

99.9 > PRESET B > 0

In principle, 1 shot or continuous shot will be output from OUT1 to OUT4 under the condition of
"count display > ( < )Preset A (PresetB)
However, if +2stages preset operation or ±1stage preset operation was chosen, and used with
the condition of "with re-output" or "without automatic reset", the condition will be as below
irrespectively of the mode chosen (UP/DOWN).

Output set ON (continuous, 1 shot) :

Count display

≤

(

≥

) Preset A(Preset B)

Output set OFF (continuous, 1 shot*) :

Count display <(>) Preset A(Preset B)

* choosing 1shot makes output "ON"

(Display)

(Continuous)

(Display)

(Continuous)

(Display)

(Continuous)

(Batch
Counter)

(Batch Counter) 0

(Display)