SHIMPO DT-601CG - Manual (Page 20)

2. Which mode to be set
1. Set the multiplying factor per one input signal.
Mode 01(P.22) A input Setting of scaling data (converter)
Mode 02(P.23) A input Setting of EXP value and frequency divider.
Mode 03(P.24) B input Setting of scaling data (converter)
Mode 04(P.24) B input Setting of EXP value and frequency divider.
2. About calculation and measurement method
Mode 00 (P.19) setting of calculation measurement method
* This setting is mandatory when RE option is chosen.
Mode 08 (P.31-33) setting of overscale display
3. About alarm output (OUT1-4)
Mode 05 (P.25-27) Setting of alarm output 1
Mode 06 (P.28-29) Setting of alarm output 2
Mode 07 (P.30) Setting of alarm output 3
For the method of setting preset value, refer to P.43
4. About analog output (AV/AI option)
Mode 10 (P.36-37) Analog output : setting of output style, output digit, reverse output,
and output display
Mode 11 (P.38-39) Analog output : setting of the display value at the maximum output
5. About the display
(1) Display after the decimal point
Mode 00 (P.19) Display 1 : position of decimal point Display 2 : setting of decimal point position
(2) Clear the display
Mode 08 (P.31-33) Setting of blank display
(3) Change the arithmetic measurement display value after reset
setting of display offset (P.44)
(4) Clear the last measurement data while the power is on
Mode 09 (P.34- 35) Reset mode while the power is on
(5) Clear Display 1 or 2 while resetting
Mode 09 (P.34-35) selection of reset display
(6) Switch between display 1 and 2 by key input
Mode 00 (P.19) Display selection
(7) Switch between display 1 and 2 by external input
Mode 08 (P.31-33) selection of external input functions
6. About other functions
(1) About usage of external output (forbidden, hold, lapcount, display switch)
Mode 08 (P.31-33) seleciton of external input fucctions
(2) About reset key action
Mode 09 (P.34-35) reset key action mode
(3) Protect mode setting value
Mode protect function (P.45)
(4) Output display value by BCD (B option)
Mode 12 (P.40-41) Setting of BCD output
(5) Input preset value by BCD (BI option)
Mode 13 (P.42-43) setting of BCD input
P18