KROHNE Summit 8800 Vol 3 - Manual (Page 101)

101 www.krohne.com
08/2013 - MA SUMMIT 8800 Vol3 R02 en
SUMMIT 8800 REPORTING 07
Figure 132 Ethernet reporting print conditions
There are 4 conditions to start the job:
On an event, like a fault or alarm
Event variables
Tick on the ID tree one or more boxes on which the event print should occur.
Manually via the print jobs screen at the Summit
Show on print menu
Click if the job must be show in print menu of the main menu for manual
trigger
On change of state of a variable
Print on change of
Select the variable ID from the list.
Care should be taken when selecting the ID as a print will be generated on
each change in state.
On interval, to print the job at a regular time intervals
Print every
Select the interval between two reports from the list
The print job also defines where to send the report to and which data to use:
Figure 133 Ethernet reporting select printer and print data
Select the destination and report data
Printer Select the destination from the list of printer. The printer refers to the
hardware settings.
Use print data Select the report to be sent from the list of print data.
The report may be using actual or archive data. To be able to re-print a report, an archive is
needed: