GW Instek GSP-827 User Manual - Manual (Page 9)

2.7GHz Spectrum Analyzer Operation Manual
⎯ ⎯
8
3.0 Product Option information
Ordering information Description
GSP-827 Spectrum Analyzer, 9k~2.7GHz
Option 01 Tracking Generator, 9k ~ 2.7GHz
Option 02
AC/DC/Battery operation power supply with battery pack
100 ~ 240 VAC, 12VDC and Battery operation triple mode Power
supply.
Battery : Li-Ion x 2. Chargeable with AC line.
(1)
Option 03
Medium stability Time base
Temperature: ±1ppm
Aging: ±1ppm/yr
Option 06 GPIB Interface
Option 07 GSC-001: Soft Carrying case
Option 08
General kit Set
ADP-002: SMA (J/F) to N (P/M) adaptor × 2
ATN-100: 10dB Attenuator × 1
GTL-303: RF Cable assembly ( RD316 + SMA (P) × 2, 60cm ) × 2
GSC-002: Kit box × 1
Option 09
CATV kit set
ADP-001: BNC (J/F) to N (P/M) adaptor × 2
ADP-101: BNC (P/M) 50Ω to BNC (J/F) 75Ω adaptor × 2
GTL-304: RF Cable assembly ( RG223, N(P)-N(J), 30cm ) × 2
GSC-003: Kit box × 1
Option 10
RLB kit set
GAK-001: Cal. Kit, termination, N, 50Ω × 1
GAK-002: Cap with chain × 1
GTL-302: RF Cable assembly ( RG223 + N (P) × 2, 30cm ) × 2
GSC-004: Kit box × 1
Option 11 GTL-401: DC Power line
Opt. 12 EMI Filters(*) RBW Selections: 9kHz and 120kHz, 6dB bandwidth,
RBW Accuracy: 15%
Opt. 13 Demodulator(*) Demodulator: AM, FM
Output: Internal speaker, 3.5mm stereo jack wired for mono
operation.
Opt. 14 EMI filters and
300Hz RBW(*)
RBW Selections: 9kHz and 120kHz, 6dB bandwidth, 300Hz, 3dB
bandwidth
RBW Accuracy: 15%
Opt. 15 EMI Filters and
Demodulator(*)
RBW Selections: 9kHz and 120kHz, 6dB bandwidth,
RBW Accuracy: 15%
Demodulator: AM, FM
Output: Internal speaker, 3.5mm stereo jack wired for mono
operation.
Opt 16 EMI Filters, 300Hz
RBW, and Demodulator(*)
RBW Selections: 9kHz and 120kHz, 6dB bandwidth, 300Hz, 3dB
bandwidth
RBW Accuracy: 15%
Demodulator: AM, FM
Output: Internal speaker, 3.5mm stereo jack wired for mono
operation.
Note(*): Only one option could be selected among option 12 to 16 for any GSP-827.
Note (1): The Battery Pack works and be charged with AC line only the DC/AC dual mode power
supply is installed. It is not charged at DC operation. It is charged under both power ON
and Standby modes.