GW Instek GSP-827 User Manual - Manual (Page 6)

2.7GHz Spectrum Analyzer Operation Manual
⎯ ⎯
5
FOR UNITED KINGDOM ONLY
NOTE: This lead / appliance must only be wired by competent persons
WARNING: THIS APPLIANCE MUST BE EARTHED
IMPORTANT: The wires in this lead are coloured in accordance with the following code:
Green/ Yellow: Earth
Blue: Neutral
Brown: Live (Phase)
As the colours of the wires in main leads may not correspond with the colours marking identified in
your plug/appliance, proceed as follows:
The wire which is coloured Green & Yellow must be connected to the Earth terminal marked with
the letter E or by the earth symbol or coloured Green or Green & Yellow.
The wire which is coloured Blue must be connected to the terminal which is marked with the letter
N or coloured Blue or Black.
The wire which is coloured Brown must be connected to the terminal marked with the letter L or P
or coloured Brown or Red.
If in doubt, consult the instructions provided with the equipment or contact the supplier.
This cable/appliance should be protected by a suitably rated and approved HBC mains fuse: refer to
the rating information on the equipment and/or user instructions for details. As a guide, cable of
0.75mm 2 should be protected by a 3A or 5A fuse. Larger conductors would normally require 13A
types, depending on the connection method used.
Any moulded mains connector that requires removal /replacement must be destroyed by removal of
any fuse & fuse carrier and disposed of immediately, as a plug with bared wires is hazardous if a
engaged in live socket. Any re-wiring must be carried out in accordance with the information
detailed on this lable.
Use and Wear
CAUTION
• Do not exceed +30 dBm into the RF INPUT or +30 dBm reverse power into the TG OUTPUT.
• Do not place any heavy object on the instrument.
• Avoid severe impacts or rough handling that could damage the GSP-827.
• Use electrostatic discharge precautions while handling and making connections to the GSP-827.
• Do not place wires into the connectors of the GSP-827, only mating connectors and adapters.
• Do not block or obstruct cooling fan vent opening on side panels or on the rear panel of unit.
• This equipment is not for measurements performed for CAT II, III, and IV.