GW Instek GSP-827 User Manual - Manual (Page 24)

2.7GHz Spectrum Analyzer Operation Manual
⎯ ⎯
23
F3
Config>
The system configuration will be shown up, including serial
number, S/W and F/W version number, Options, Los status,
reference signal source and status.
F6
Exit the submenu.
6.2.24 Synchronized by External Reference Signal
Function key Description
Option Select the Option relative functions.
F3
Freq>
Select the external reference signal source.
Up/Down
Arrows
or
Spinner
Select the reference signal frequency.
-
Connect the reference signal source to the BNC terminal
“Ref Input” on the rear panel.
6.2.25 Synchronize other equipments
Connect the “10MHz Ref Output” terminal on the rear panel to the “External Ref. Input” of
following equipment directly.
6.2.26 Tracking Generator Operation (option)
Function key Description
Option Select the Option relative functions.
F1
Select the Tracking Generator.
F2
>
Set the TG output Level.
F1
Switch the TG ON.
F3 Perform the Normalization function before connecting the
DUT if necessary.
F5
Value>
This function allows normalization on the specific level for
extra gain or loss.