Edwards Signaling 2400 Series - Manual (Page 34)

26
NOTE
When verifying the operation of strobe lights using the Test Mode, the strobe lights may
not receive enough energy to successfully charge. Use independent test methods such
as Drill Mode to verify strobe lights and field wiring.
NOTE
Before exiting Test Mode, be sure to Enable the zone(s) that were Disabled for testing.
CAUTION
If there is no activity on the system for 30 minutes, the system will exit the Test Mode
and the Disabled zone(s) will remain Disabled.
To exit the test mode, press and hold the RESET switch for one second.
Dialer Operations
Refer to
Dialer Operations drawing
Table 6.3 - Dialer LED Indications
Display Description
Single Flash Green Call to Central Monitoring Station in
progress.
Steady RED Alarm Sent & Acknowledged
Fast Flash AMBER Supervisory alarm sent & Acknowledged
Steady AMBER Supervisory restore sent & acknowledged.
Single Flash AMBER Module in trouble
Double Flash AMBER Module disabled
Remote Trouble Unit
The green Power LED will be on whenever the RTU is receiving power from the control panel.
The Amber Trouble LED will be on whenever the control panel is in trouble.
The Trouble Buzzer will sound when the control panel is in trouble and the trouble silence switch is in the
normal position, and will sound when the control panel is not in trouble and the trouble silence switch is in
the silence position.