AW Gear Meters EMO-3000 - Manual (Page 27)

EMO‐3000
Operation and Programming Manual
26
ENTER PASS CODE = XXXX
The code is 4146.
Key in the correct value and Enter with F6.
F5 = ANALOG VARIABLES
* * * ANALOG VARIABLES * * * CH = XXX
‐‐‐‐> mAs OFFSET = XXX.XX
mAs GAIN = XXXXX.
mAs SHIFTER = XXXXX.
mAs POINTER = XXXXX.
Volts OFFSET = XX.XXX
Volts GAIN = XXXXX.
F1 = ESC F2 = PGUP F3 = PGDN F4 = PRGM
Use F2 = PGUP to access the four variables in the ANALOG VARIABLES screen. These variables are:
Volts SHIFTER = XXXXX.
Volts POINTER = XXXXX.
mAs IN OFFSET = XXX.XX
Vos IN OFFSET = XXX.XX
When the desired variable moves to the arrow, select F4 = PROGRAM. The DM‐3000 then asks for the
pass code.
ENTER PASS CODE = XXXX
The code is 4146.
Key in the correct variable value and Enter with F6.
F6 = LIMIT VARIABLES
* * * LIMIT VARIABLES * * * CH = XXX
‐‐‐‐> TOTAL LIMIT 1 = XXXXX.
TOTAL LIMIT 2 = XXXXX.
TOTAL LIMIT 3 = XXXXX.
TOTAL LIMIT 4 = XXXXX.
FLOW LIMIT 1 = XXXX.X
FLOW MARGIN 1 = XXXX.X
F1 = ESC F2 = PGUP F3 = PGDN F4 = PRGM
Notice