AW Gear Meters EMO-3000 - Manual (Page 21)

EMO‐3000
Operation and Programming Manual
20
SINGLE CHANNEL DISPLAY 1
MONITOR MODE DSP 01 CHANNEL = XX
RATE = XXXX.ccm
TOTAL = XXXX.cc GRAND = XXXX.cc
LIMIT 1 ‐ ‐>OFF
LIMIT 2 ‐ ‐>OFF
LIMIT 3 ‐ ‐>OFF
LIMIT 4 ‐ ‐>OFF
F1=ESC F2=CHNL UP F3=CHNL DN F5 = D+
 F2 pages UP through the channels.
 F3 pages DOWN through the channels.
 F5 calls up PID displays 2 and 3.
Below is the second of the two single channel display screens. Select F5 = D+ in the first screen to enter
this screen.
SINGLE CHANNEL DISPLAY 2
MONITOR MODE DSP 02 CHANNEL = XX
MA OUTPUT =XX.XX mA INPUT=XX.XX
V OUTPUT =X.XXX V INPUT=X.XXX
TOTALIZER = XXXXXXX. cc
GRAND TOT = XXXXXXX. cc
F1=ESC F2 = TOT RESET F3 = GRA RESET F5 = D+
 F2 resets the totalizer.
 F3 resets the Grand Total.
 F5 calls up the first single channel screen in Monitor Mode.
F2 = SINGLE CHANNEL DISPLAY ‐ PID Mode
The next three displays are for PID Mode only.
Notice