AW Gear Meters EMO-3000 - Manual (Page 22)

EMO‐3000
Operation and Programming Manual
21
SINGLE CHANNEL DISPLAY 1 ‐ PID
P I D MODE DSP 01 CHANNEL = XX
RATE = XXXX.X ccm FLUID NBR = 00
SET = XXX.XX ccm mA OUTPUT = 00.00
TRANSPARENT ‐ ‐ > OFF
HOLD ANALOG ‐ ‐ > OFF
HOLD TOTAL ‐ ‐ > OFF
SET REACHED ‐ ‐ > OFF
F1=ESC F2 = UP F3 = DN F5 = D+
 F2 pages UP through the channels.
 F3 pages DOWN through the channels.
The channel selection for programming is performed in this screen.
 F5 calls up the second Single Channel screen.
SINGLE CHANNEL DISPLAY 2 ‐ PID
P I D MODE DSP 02 CHANNEL = XX
MA OUTPUT = XX.XX mA INPUT=XX.XX
V OUTPUT = X.XXX V OUTPUT=X.XXX
TOTALIZER = XXXXXXX. cc
GRAND TOT = XXXXXXX. cc
F1=ESC F2 = TOT RESET F3 = GRA RESET F5 = D+
 F2 resets the totalizer.
 F3 resets the Grand Total.
 F5 calls up the third channel screen for PID Mode.
Notice