Condec DLR3110 - Manual (Page 33)

Configuration and Calibration 29
Port One Simplex Modify Menu
Table 5-18 outlines the parameters of the Port 1 Simplex Modify menu.
5.13.6 Port 2 Set-Up
Port 2 has the same set-up as Port 1 for the PRINTER or SIMPLEX modes. Port 2 does not have a DUPLEX
mode. All references to Port 1 are replaced with Port 2 for its PRINTER or SIMPLEX modes.
LED Display Alpha-Numeric Display Key Pressed Remarks
PORT 1 MODIFY DOWN arrow Enters Modify menu
DELAY 1 AUTO UP or DOWN
arrow
Press LEFT or RIGHT arrow keys to
change the current state of the selection.
1/SEC, 2/SEC, 3/SEC, 4/SEC, 5/SEC or
AUTO
T-D1 OFF Press LEFT or RIGHT arrow keys to
change the current state of the selection.
ON ONE, ABOVE, BELOW or OFF
DATA 1 DISPLAY Press LEFT or RIGHT arrow keys to
change the current state of the selection.
DISPLAY, G/T/N or COMPRESS
EOL 1 CR/LF Press LEFT or RIGHT arrow keys to
change the current state of the selection.
CR/LF or CR
SOT 1 STX Press LEFT or RIGHT arrow keys to
change the current state of the selection.
NONE, SOH, or STX
EOT 1 NONE Press LEFT or RIGHT arrow keys to
change the current state of the selection.
EOT, ETX, FF, LF, or NONE
PORT 1 EXIT ? YES key Return to menu SET-UP/PORT 1 ?. See
Table 5-10 on page 24.
NO key Return to menu PORT 1/SIMPLEX. See
Table 5-17 on page 28.
Table 5-18. Port 1 Simplex Modify Parameters