Condec DLR3110 - Manual (Page 19)

Configuration and Calibration 15
5.5.2 Auto Set-Up Menu (Gage)
See Section 9.0 on page 63 for a complete listing of the default settings for all gage and absolute selections under
the AUTO set-up mode.
NOTE: If you continue to press NO key past highest full scale range, DLR3110 will go to exit menu. Hit YES key at exit
menu (see Table 5-3 on page 14).
LED Display Alpha-Numeric Display Key Pressed Remarks
SET AUTO ? YES key See Section 5.5 on page 14
---- GAGE ? YES key See Section 5.5 on page 14
SET-UP 3 PSIG ? NO key Continue to press NO key until the
alpha-numeric display shows the
DLR3110’s full scale range.
YES key Press YES key when the alpha-numeric
display shows the DLR3110’s full scale
range.
SET-UP ACCEPT ?
YES or NO.
NO key Continue to press NO key until the
alpha-numeric display shows the
DLR3110’s full scale range. See note
below.
YES key Accept data
XXXX CAPACITY YES key “XXX” shown on LED display represents
the full scale range and is based on
previous selection.
— EXIT ? YES key Return to SET-UP/ I/O?. (see Section 5.4
on page 13).
NO key Returns to XXX/CAPACITY
Table 5-4. Auto Set-Up Mode (Gage) Parameters Selections