Brocade Fabric Watch Administrators Guide (Supporting Fabric OS v7.3.0) - Manual (Page 61)

16 Gbps and QSFP configurable SFP types (Continued) TABLE 13
SFP Type Serial
Number Area Default High Default Low
TXP (μW) 1999 125
Current (mA) 10 3
10GLWL KD Temperature (°C) 90 -5
Voltage (mV) 3600 2970
RXP (μW) 2230 14
TXP (μW) 2230 60
Current (mA) 95 10
Others N/A Temperature (°C) 85 -10
Voltage (mV) 3630 2970
RXP (μW) 5000 0
TXP (μW) 5000 0
Current (mA) 50 0
Refer to the Fabric OS Command Reference for details on using the --sfpType operand as part of the
thconfig command.
Displaying the number of 16 Gbps SFP operational hours
To show the number of hours that the 16 Gbps SFP is operational, enter the thConfig command using
the following parameters. The only supported time base for this area is none.
switch:admin> thconfig --show sfp -area PWRONHRS -sfptype 16GSWL
Displaying the SFP health information
To display the health of 10 and 16 Gbps SFPs and QSFPs, enter the sfpshow --health command.
Fabric Watch monitors the current, voltage, receiver (RXP) of the SFP, and transmitter (TXP) and if any
of these parameters crosses the low or high thresholds, the state of the SFP is yellow; otherwise, the
state is green. The SFP can also be in one of the following states:
• Paused — Health monitoring is not enabled.
• No license — The switch does not have the Fabric Watch license.
• Unknown — Fabric Watch cannot determine the state of the SFP.
Displaying the number of 16 Gbps SFP operational hours
Fabric Watch Administrators Guide 61
53-1003142-01