beautypg.com

Fabric monitoring setting guidelines, Fabric class default settings – Brocade Fabric Watch Administrators Guide (Supporting Fabric OS v7.3.0) User Manual

Page 48

background image

Fabric class areas (Continued)

TABLE 3

Area

Description

Segmentation changes
(SC)

Tracks the cumulative number of segmentation changes. Segmentation changes occur
because of one of the following:

• Zone conflicts.
• Incompatible link parameters. During E_Port and VE_Port initialization, ports

exchange link parameters, and incompatible parameters result in segmentation.
This is a rare event.

• Domain conflicts.
• Segmentation of the principal link between two switches.

Zone changes (ZC)

Tracks the number of zone changes. Because zoning is a security provision, frequent
zone changes might indicate a security breach or weakness. Zone change messages
occur whenever there is a change in zone configurations.

Fabric monitoring setting guidelines

It is recommended that you leave the entire Fabric class in its default state (no alerts) for the following
reasons:

• Domain ID changes

Plan and use strict change control practices to avoid Domain ID changes.

• Loss of E_Port

Detect if an E_Port is down using the E_Port class areas.

• Fabric logins

In a large environment of numerous devices, this area is of no interest.

• Fabric reconfiguration

Fabric reconfigurations typically occur when new switches are added to a fabric, which is a planned
activity, or when an upstream or downstream ISL fails, which is detected through the E_Port class
areas. Because fabric reconfigurations are monitored elsewhere, do not change the default settings
for the Fabric class.

• Segmentation changes

Segmentations only occur in the event of an entire switch failure. In this rare case, you can gather
multiple reports from all the attached E_Ports of the link failures.

• Zoning changes

Zone changes are captured through the Audit facility in Fabric OS. All zone changes can be
configured to be recorded in the RASLog, which is the recommended practice.

Fabric class default settings

The table below provides default settings for areas in the Fabric class.

Fabric monitoring setting guidelines

48

Fabric Watch Administrators Guide

53-1003142-01