Yokogawa µR20000 - Manual (Page 17)

2-4
IM 04P01B01-61E
2.3 Loading the Setup Data or Creating New Setup
Data
The following three methods are available for creating setup data.
• Load the setup data of the recorder
• Open a setup data file.
• Create new setup data.
Loading the Setup Data of the Recorder
Before carrying out the following procedure, check to see that the communication
mode and parameters are set correctly. For details, see section 2.2, “Setting the
Communication Mode for Connecting to the Recorder.”
1. From the Communication menu, choose Receive Setting. You can also click
the Receive setting icon on the toolbar. A confirmation dialog box for receiving
settings opens.
Receive setting icon
2. Click OK.
The reception starts. When the reception of the settings is complete, a message
appears to indicate it.
3. Click OK.
The loaded setup data is displayed.
Note
• If the message in the figure below appears, check the following:
• That the communication settings are matched with the settings on the recorder.
• That there are no users accessing the recorder or that the maximum number of users is
not exceeded.
• Note that if setup data is received when the recorder is in Basic Setting mode, the setup
data in the middle of the configuration will be received.