Yokogawa µR20000 - Manual (Page 11)

1-3
IM 04P01B01-61E
Before Using the Software
1
2
3
4
Index
1.3 Installing the Configuration Software
A serial number is required to install the configuration software. The serial number is
indicated on the CD-ROM case. Please have the serial number ready.
Installing the Software
1. Start Windows. Log onto Windows as an administrator.
2. Insert the CD-ROM containing the software into the CD-ROM drive.
The installation program starts automatically.
3. Click the Run button for the Configuration Installation. Proceed with the
installation according to the instructions that appear on the screen.
If the installation program does not start automatically, carry out the procedures
below.
4. Double-click the CD-ROM icon from “My Computer” to open the CD-ROM drive
window.
5. Double-click the “Setup.exe” file in the root directory. The installation will start after
a short time. Then, follow the instructions on the screen.
Note
• Exit memory resident programs such as virus protection programs before installation.
• Set the OS and program languages to the same language. Normal operation cannot be
guaranteed if you install the software under a different language than the OS.
• When reinstalling the software, uninstall it first.
• To uninstall the program, follow the procedures below.
1. Double-click “Add/Remove Programs” in the Control Panel and uninstall the program.
2. As necessary, back up the setup data files with .pul extension in the directory in which
the configuration software was installed to a different directory.
3. Delete the files (various data files and subdirectories) that were created after the
installation of the program. Also, delete the directory in which the program was installed.