Yokogawa Removable Chassis DX1000N - Manual (Page 44)

2-14
IM 04L41B01-04E
Attribute Description Default value
2nd span Upper Enter a value between 0.0% for the lower limit and 100.0%
for the upper limit. In this case, the difference between the
two spans needs to be 10.0% or greater.
See Section 2.2.
100.0
Depend ID Set the ID number of the component on which this
component is dependent.
See Section 2.2.
None
Visible You can choose to show or hide this component by setting
[On] or [Off].
See Section 2.2.
On
Sync act See Section 2.2.
Note
• To display the indicator bar and color scale band configured when you set the type to [Bitmap],
you will need to fill the background of bitmap with R:252, G:228, and B:180.
• Conditions for reading a bitmap
(1) Do not compress down to a format of 256 colors or fewer
(2) 640 (width) x 480 (height) pixels or fewer (the bitmap cannot be read if the value exceeds
either 640 or 480.)
When scale marks overlap
• When selecting [Micro] for the mark format
If the scale positions of multiple channels overlap, their marks overlap. When
overlapping, marks are staggered to prevent their points from overlapping, but when
the scale format is [Small] or [Large] with 4 or more, or 6 or more marks respectively,
the points will overlap.
Example of a mark display when the scale type is [Small]
No. of CH: 5
No. of CH: 2
No. of CH: 3
Overlapping indicators since more than 4 marks at the same position
No overlapping indicators since 3 or fewer marks at the same position
When indicators overlap at the same position
• When selecting [Small] for the mark format
If the scale positions of multiple channels overlap, their marks overlap. If marks
overlap, they are staggered to prevent the channel numbers from overlapping, but
under the following conditions, the channel numbers also overlap.
• Waveform direction is [Vertical], scale format is [Large], and there are 4 or more
marks
• Waveform direction is [Vertical], scale format is [Small], and there are 3 or more
marks
• Waveform direction is [Horizontal] with 3 or more marks
Note that only 2 digits of the channel number are displayed.
2.6 Attributes of Scale Components