Yokogawa Removable Chassis DX1000N - Manual (Page 20)

1-14
IM 04L41B01-04E
1.8 Copy Components (Copy and Paste)
Procedure
1. Use the arrow key to place the cursor on the component which you want to copy.
2. Press the COPY soft key.
3. Use the arrow key to move the cursor to the point where you want to place a
component.
4. Press the PASTE soft key.
Copied components are pasted.
Explanation
All contents to be copied are attribute information excluding the ID, depend ID, group
control, and Gr.ctrl order. The ID number is assigned in the order of component creation.
If you attempt to create components exceeding the number of components which can be
created, you cannot copy any component.
If you press the PASTE soft key at the cursor position shown in the lower left figure, a
component is placed as the lower right figure shows. A component is placed so that it
does not go over the screen.