Watlow Series 97 - Manual (Page 49)

Active if Output 2 hardware is
present (not 97 _ _-_ A _ _-_ _ _
_) and Setup Page Lock
(Lockout Menu) is not set to
[hide].
717 r/w [`OFF] [`OFF] off (0)
[`AL`] alarm (1) [Ot`2] Output 2
Selects output 2
function.
[Out2] Output 2 Menu
[`set] Setup Page
Active: Always. 507 r/w 3 1 to 9999 [LhYS] Limit Hysteresis
Sets the switching
hysteresis for output
1.
Active: Always. 700 r/w [both] [both] both (0)
[`hi`] high (1)
[`Lo`] low (2) [LSid] Limit Active Sides
Selects output 1
active sides.
[Out1] Output 1 Menu
[`set] Setup Page
Active if Input 2 hardware is
present (97 _1 _-_ _ _ _ -_ _ _ _),
Input 2 (Input 2 Menu) is set to
[E`in] (Event Input), Event
Function (Input 2 Menu) is not
set to [none] and Setup Page
Lock (Lockout Menu) is not set
to [hide].
1061 r/w
[`Lo`]
[`Lo`] low (0)
[`hi`] high (1)
[rise] rise (2)
[FALL] fall (3) [E`cn] Event Condition
Selects the condition
to trigger an event.
Active if Input 2 hardware is
present (97 _1 _-_ _ _ _ -_ _ _ _)
or Input 2 (Input 2 Menu) is
set to [E`in] (Event Input)
and Setup Page Lock (Lockout
Menu) is not set to [hide].
1060 r/w [nonE] [none] no function (0)
[Lrst] reset limit (1)
[`LOC] lock out key
board (2)
[`ALr] clear and
silence alarms if
possible (3)
[E`Fn] Event Function
Selects the event
function.
Active if Input 2 hardware is
present (97 _1 _-_ _ _ _ -_ _ _ _)
and Setup Page Lock (Lockout
Menu) is not set to [hide].
611 r/w 0 [`OFF] off: (0)
[E`In] Event Input:
(1)
[In`2] Input 2
Sets the input type
parameter of input
2.
[Inp2] Input 2 Menu
[`set] Setup Page
Wa t l o w S e r i e s 9 7 P a r a m e t e r s ■ 6 . 9
Setup Page / Input 2 and Output 1 Menus
Display Parameter Range Default Modbus Conditions for
Address Parameters to Appear
read/write
NOTE: For more information about how parameter settings affect the controller’s operation, see Chapter Five, Features.