Watlow Power Series Rev H - Manual (Page 44)

Active if retransmit and heater
diagnostics options are installed.
871 r/w [`CUr] cur-
rent (1)
[`Off] none (0)
[`CUr] current (1)
[`HUA] kVA (2) [type] Retransmit Type
Select
Select type of
retransmit informa-
tion; amps or kVA.
Active if retransmit and heater
diagnostics options are installed.
870 r/w {`nna] mA
(0)
{`nna] mA (0)
{UOlt] volts (1) [`Cf9] Retransmit
Config. Select
Select type of
retransmit output.
[rEtr] Setup Retransmit Configuration Menu
[`Set] Setup Page
This menu is used to set up the retransmit parameters. The menu is not available unless
Retransmit and Heater Diagnostics are installed.
Active if serial communications
option is installed and [`Wd]
Watchdog is set to {``On].
87 r/w [``)0] 0 per-
cent (0)
[``)0] 0 percent to
[10)0] 100 percent
(0 to 1000)
[PWr] Watchdog Failure
Output Power
Select
Selects the default
power level for a
watchdog timeout.
Active if serial communications
option is installed and [`Wd]
Watchdog is set to {``On].
86 r/w [9999]
(9999)
[```0] to [9999] (0
to 9999)
[`seC] Watchdog Timeout
(Sec)
Selects a timeout in
seconds for the
communications
watchdog.
Active if serial communications
option is installed.
85 r/w {`Off] off (0) {`Off] off (0)
{``On] on (1) [`Wd] Watchdog Select
(On/Off)
Turns on a watchdog
for communications.
Active if serial communications
option is installed.
[9600] 9600
baud
[1200] 1200 baud
[2400] 2400 baud
[4800] 4800 baud
[9600] 9600 baud
[1(2`] 19.2K baud [baud] Unit Baud Rate
Select
Select baud rate for
communications.
Active if serial communications
option is installed.
[```1] [```1] to [`247] [Addr] Unit Address Select
Select device
address for
communications.
[COm] Setup Comms Configuration Menu
[`Set] Setup Page
This menu is used to set up the communications parameters. This menu is not available unless
Serial Communications is installed.
6 . 1 2 ■ Wa t l o w P o w e r S e r i e s P a r a m e t e r s , C h a p t e r 6
Display Parameter Range Default Modbus Conditions for
(Modbus Value) Register Parameters to Appear
read/write