Watlow Power Series Rev H - Manual (Page 34)

Active if heater diagnostics option
is installed and heater bakeout
is running in the zone.
157 r [1]
167 r [2] n/a [9999] to [```0]
[minutes]
(9999 to 0)
[Hbt1], [Hbt2] Heater
Bakeout Timeout
Displays the time
left on a heater
bakeout.
Active with multizone
configuration.
159 r [1]
169 r [2] [``)0] [``)0] to [10)0]
(0 to 1000)
[Out1], [Out2]
Output Power (%)
Displays present out-
put power.
Active with multizone
configuration.
mA, r [1][2]
150,160
V, r [1][2]
151,161
dig, r/w [1][2]
5102, 5202 [``)0] [``)0] to [1)00] [V]
(0 to 1000)
[``)0] to [2)00] [mA]
(0 to 2000)
[``)0] to [10)0] [%]
(0 to 1000)
0.1 increments
[In`1], [In`2]
Analog (mA or V)
or Numeric (%)
Input Signal
Displays mA/V
analog input; selects
numeric % power.
Active with multizone
configuration.
n/a 1 [```1] to [```2] [```1] , [```2]
[2one] Display Zone
Selection
Select Zone 1 or 2 for
display.
Two Zone, Single Phase
Active if heater diagnostics option
is installed.
156 r n/a [```0] to [9999]
(0 to 9999)
[`HUa] Load Power
(kVA)
Displays (est.) calcu-
lated load power.
Active if heater diagnostics option
is installed.
164 r n/a [```0] to [9999]
(0 to 9999)
[`Cur] Load Current
(Amps) rms
Displays measured
load current.Peak
current converted to
rms, then multiplied
by % power = aver-
age rms current
measured by the on-
board CT.
Active: Always.
Appears in Display Loop. 162 r n/a [```0] to [9999]
(0 to 9999)
[`UoL] Line Potential
(Volts) rms
Displays measured
line voltage.
Active if heater diagnostics option
is installed and heater bakeout
is running in the zone.
157 r [1] n/a [9999] to [```0]
[minutes]
(9999 to 0)
[`Hbt] Heater Bakeout
Timeout
Displays the time
left on a heater
bakeout.
Active: Always.
Appears in Display Loop. 159 r [``)0] [``)0] to [10)0]
(0 to 1000)
[`Out] Output Power (%)
Displays present out-
put power.
6 . 2 ■ Wa t l o w P o w e r S e r i e s P a r a m e t e r s , C h a p t e r 6
Display Parameter Range Default Modbus Conditions for
(Modbus Value) Address Parameters to Appear
read/write