Figure 4-4: cooling kit support bracket – IEI Integration NANO-HM650 User Manual

Page 60

NANO-HM650 EP IC S BC

P a g e 45

To install the cooling kit, please follow the steps below.

S te p 1:

Place the cooling kit onto the CPU. Make sure the CPU cooling fan cable

can be properly routed when the cooling kit is installed.

S te p 2:

Properly align the cooling kit. Make sure its four spring screw fasteners can

pass through the pre-drilled holes on the PCB.

S te p 3:

Secure the cooling kit. From the solder side of the PCB, align the support

bracket to the screw threads on heat sink that were inserted through the PCB

Figure 4-4: Cooling Kit Support Bracket

S te p 4:

Tighten the screws. Use a screwdriver to tighten the four screws. Tighten each

nut a few turns at a time and do not over-tighten the screws.

S te p 5:

Connect the fan cable. Connect the cooling kit fan cable to the fan connector

on the motherboard. Carefully route the cable and avoid heat generating chips

and fan blades.