IEI Integration NANO-HM650 - Manual (Page 57)

NANO-HM650 EP IC S BC
P a g e 42
4.3 Ba s ic In s ta lla tio n
WARNING:
A CPU should never be turned on without the specified cooling kit
being installed. If the cooling kit (heat sink and fan) is not properly
installed and the system turned on, permanent damage to the CPU,
NANO-HM650 and other electronic components attached to the
system may be incurred. Running a CPU without a cooling kit may also
result in injury to the user.
The CPU, CPU cooling kit and DIMM are the most critical components of the
NANO-HM650. If one of these component is not installed the NANO-HM650 cannot run.
4.3.1 S o c ke t G2 CP U In s ta lla tio n
WARNING:
CPUs are expensive and sensitive components. When installing the
CPU please be careful not to damage it in anyway. Make sure the CPU
is installed properly and ensure the correct cooling kit is properly
installed.
DO NOT touch the pins at the bottom of the CPU. When handling the
CPU, only hold it on the sides.
To install a socket G2 CPU onto the NANO-HM650, follow the steps below:
S te p 1: Unlock the CPU retention screw. When shipped, the retention screw of the
CPU socket should be in the unlocked position. If it is not in the unlocked
position, use a screwdriver to unlock the screw. See Figure 4-1.