1 anti-static precautions, 2 installation considerations, Static – IEI Integration NANO-HM650 User Manual
Page 55: Recautions, Nstallation, Onsiderations, 2 in s ta lla tio n co n s id e ra tio n s

NANO-HM650 EP IC S BC
P a g e 40
4.1 An ti-s ta tic P re c a u tio n s
WARNING:
Failure to take ESD precautions during the installation of the
NANO-HM650 may result in permanent damage to the NANO-HM650
and severe injury to the user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the NANO-HM650. Dry climates are especially susceptible to ESD. It is therefore
critical that whenever the NANO-HM650 or any other electrical component is handled, the
following anti-static precautions are strictly adhered to.
Wear an anti-static wristband: Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.
Self-grounding: Before handling the board, touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.
Use an anti-static pad: When configuring the NANO-HM650, place it on an
antic-static pad. This reduces the possibility of ESD damaging the
NANO-HM650.
Only handle the edges of the PCB: When handling the PCB, hold the PCB
by the edges.
4.2 In s ta lla tio n Co n s id e ra tio n s
NOTE:
The following installation notices and installation considerations should
be read and understood before installation. All installation notices must
be strictly adhered to. Failing to adhere to these precautions may lead
to severe damage and injury to the person performing the installation.