IEI Integration NANO-LX v1.10 - Manual (Page 95)

NANO-LX EPIC SBC
Description Label Type
AT/ATX Power Mode Select 2-pin header JP4
COM1, COM2 RI Pin and Voltage Selection (Optional) 10-pin header JP2
COM3 RS422/RS485 Select 3-pin header JP3
LCD Panel (LVDS/TTL) Voltage select 2-pin header JP7
LCD PANEL SHIFT CLOCK 3-pin header JP1
PC104 Plus VIO Voltage Select 3-pin header JP5
SERIRQ Select 2-pin header JP6
AT/ATX Power Mode Select 2-pin header JP4
COM1, COM2 RI Pin and Voltage Selection (Optional) 10-pin header JP2
COM3 RS422/RS485 Select 3-pin header JP3
LCD Panel (LVDS/TTL) Voltage select 2-pin header JP7
LCD PANEL SHIFT CLOCK 3-pin header JP1
PC104 Plus VIO Voltage Select 3-pin header JP5
Table 5-1: Jumpers
NOTE:
The NANO-LX does not provide a “Clear CMOS” configuration jumper. If the
system fails to boot due to improper BIOS settings, reset the CMOS contents by
disconnecting and reconnecting the BT1 battery connector. Use small-sized
needle nose pliers to carefully disconnect and reconnect the BT1 battery
connector.
Page 95