IEI Integration NANO-LX v1.10 - Manual (Page 103)

NANO-LX EPIC SBC
5.8.3 AT Power Connection
Follow the instructions below to connect the NANO-LX to an AT power supply.
WARNING:
Disconnect the power supply power cord from its AC power source to
prevent a sudden power surge to the NANO-LX.
Step 1: Locate the power cable. The power cable is shown in the packing list in
Chapter 3.
Step 2: Connect the Power Cable to the Motherboard. Connect the 4-pin (2x2) Molex
type power cable connector to the AT power connector on the motherboard. See
Figure 5-6.
Figure 5-6: Power Cable to Motherboard Connection
Page 103