IEI Integration NANO-LX v1.10 - Manual (Page 221)

NANO-LX EPIC SBC
WARNING!
All data previously stored on the member drives of a RAID configuration will
be destroyed during the RAID initialization process. If “used” drives are used
to create a RAID array, make sure the data has been moved or backed up
before creating a RAID array out of the disk drives.
Step 1: Use the arrow keys to highlight Create JBOD for Integrated Capacity and
press E NTER . A flashing ‘J’ appears at the Drive Menu where the member drives
to be included in the JBOD can be chosen.
Step 2: Use the space bar to select members of the JBOD configuration. The flashing
cursor changes to a lower case ‘j’ once any of the connected disk drives has
been selected. Follow the same method to select another member drive. The
maximum number of member drives in a JBOD is four and the minimum is two.
Step 3: The Create RAID1(Y/N) confirm box appears. Press Y.
Step 4: Enter a nickname for the created array. Upper and lower case alphabetic,
numeric, space, and underscore characters are all applicable for naming an
array.
Step 5: Once an array is successfully created, it will be seen in the list of configured
arrays. Step 0:
NOTE:
To reduce the chance of losing data, ALi imposes certain limitations on the
RAID configuration options. Parallel-ATA drives connected on the same IDE
channel cannot be selected as the members of a RAID1 array. Avoid mixing
Parallel-ATA and Serial-ATA disk drives in a RAID1 array.
Page 221