IEI Integration IMBA-Q454 v1.01 - Manual (Page 97)

IMBA-Q454-R10 User Manual
Page 97
5.3.2 IDE Configuration
Use the IDE Configuration menu (Error! Reference source not found.) to change and/or
set the configuration of the IDE devices installed in the system.
BIOS SETUP UTILITY
Main Advanced PCIPNP Boot Security Chipset Exit
IDE Configuration
⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯
Sata#1 Configuration [Enhanced]
Configure SATA#1 as [IDE]
SATA#2 Configuration [Enhanced]
> Primary IDE Master
: [Not Detected]
> Primary IDE Slave : [Not Detected]
> Secondary IDE Master : [Not Detected]
> Secondary IDE Slave : [Not Detected]
> Third IDE Master : [Not Detected]
> Fourth IDE Master : [Not Detected]
Disabled
Enhanced
ÅÆ Select
Screen
↑ ↓ Select
Item
Enter Go to SubScreen
F1 General
Help
F10 Save and Exit
ESC Exit
v02.61 ©Copyright 1985-2006, American Megatrends, Inc.
BIOS Menu 4: IDE Configuration
Î SATA#n Configuration [Enhanced]
Use the SATA#n BIOS option to enable the nth SATA drive port.
Î
Enhanced D EFAULT The nth SATA drive port is activated
Î
Disabled The nth SATA drive port is disabled
Î Configure SATA#n as [IDE]
Use the Configure SATA#n as BIOS option to configure the nth SATA port as an IDE
drive, a SATA drive (AHCI mode) or a SATA drive in a RAID configuration.
Î
IDE D EFAULT The drive connected to the nth SATA port is configured as an
IDE drive
Î
RAID The SATA drive connected to the nth SATA drive port is
specified as a SATA drive that is part of a RAID array